LMR -400 Coaxial Cable
This Coaxial Cable Assembly uses LMR -400 Cable and JEFA Tech Connectors Times Microwave LMR -400 is a high-performance, low-loss 50-ohm coaxial cable designed for both indoor and outdoor RF communications. Manufactured using premium materials and assembled with precision ...This Coaxial Cable Assembly uses LMR -400 Cable and JEFA Tech Connectors Times Microwave LMR -400 is a high-performance, low-loss 50-ohm coaxial cable designed for both indoor and outdoor RF communications. Manufactured using premium materials and assembled with precision connectors, it delivers reliable signal transmission across a wide frequency range.
Ideal for commercial, industrial, and telecom applications. LMR is a registered trademark of Times Microwave Systems. Made in USA TAA Compliant Ro - HS and REACH Compliant Common Applications Antenna feed lines for Wi-Fi, LTE, 5G, GPS, VHF/UHF, and broadband systems Wireless infrastructure including DAS, base stations, and signal repeaters Amateur and CB radio installations Wireless surveillance and Io Technical Specifications Parameter Specification Impedance 50 ohms Velocity of Propagation 85% Inner Conductor Solid bare copper-clad aluminum (0.108" diameter) Dielectric Foam polyethylene Outer Shield Bonded aluminum tape with tinned copper braid Jacket UV-resistant polyethylene (0.405" outer diameter) Minimum Bend Radius 1 inch (installation), 4 inches (repeated) Operating Temperature Range –40°C to +85°C (–40°F to +185°F) Shielding Effectiveness Greater than 90 d - B Peak Power Handling Up to 16 k - W Weight 0.068 lbs/ft (0.10 kg/m) DC Resistance (Inner/Outer) 1.39 / 1.65 ohms per 1000 ft Attenuation Table Frequency (MHz) Attenuation (d - B/100 ft) Attenuation (d - B/100 m) 30 0.7 2.2 50 0.9 2.9 150 1.5 5.0 220 1.9 6.1 450 2.7 8.9 900 3.9 12.8 1500 5.1 16.8 1800 5.7 18.6 2000 6.0 19.6 2500 6.8 22.2 5800 10.8 35.5 QUALITY AND PERFORMANCE: This cable is professionally assembled and tested in our manufacturing facility in Maryland, USA! - PRODUCTION DETAILS: You are purchasing a completed cable assembly with connectors professionally attached to the cable.
The ends are soldered and crimped, heat shrink is applied to seal the cable to the connector and provide additional support and the cable is then tested to ensure proper assembly and performance.